View modes
You can control the viewing mode by clicking the viewing mode selector in the Versions palette, or by selecting View > Versions. You can also switch modes using the shortcuts: ‘N’ for Normal mode, ‘A’ for All and ‘C’ for compare.
•Normal Mode: Views each version as printed, one by one. The previous and next version shortcuts simply switch the version being viewed. By default, you see all plates that make up the version, but you can view the version-specific plates only.
•All Versions Mode: Shows all version specific plates on top of each other. View > All Versions or ‘A’ shortcut. If you double click a flat from within the Results tab in ‘View All’ mode, Raster Preview starts in ‘All’ mode.
The plate of the first version shown is magenta: This is the reference version. The other plates are all shown in cyan. Shifted pixels therefore stand out very clearly.
NOTE: This mode only shows version-specific plates: You cannot switch this off.
•Compare Mode: Shows the version specific plates of the master version and a version, layered on top of each other. The master and version plates appear in different colors to highlight possible shifts.
The previous and next version shortcuts keys switch the top-layered version, keeping the master plate underneath. You can also click a version in the palette to select it immediately.