Toolbar
The Toolbar at the bottom of the Product View provides quick access to common tasks and commands. These commands are also available on the main menu or by using shortcuts.
 |
NOTE: The availability of the tools and buttons on the Toolbar depends on the node you select.
Each of these tools is described below.
 | Press Sheet View button. Select a Press Sheet or Press Sheet side in the Press Sheet or Press nodes and click this button to open the Press Sheet View and view the selected Press Sheet side. | |
 | Selection tool. Use this tool to select a component or area and display its properties. This is the default tool. | |
 | Split Assembly tool. Use this tool to split blocks in the Assembly. | |
 | Repeat tool. Use this tool to repeat selected components. | |
 | Auto Impose button. Click this button to perform the Auto Impose task, for example after rearranging nodes or changing the properties of a Fold Sheet, Press Sheet or Press. | |
 | Rotate counterclockwise tool (only if Fold Sheet is selected). Rotates selected Fold Sheets 90 degrees counterclockwise on the Press Sheet. | |
 | Rotate clockwise tool (only if Fold Sheet is selected). Rotates selected Fold Sheets 90 degrees clockwise on the Press Sheet. | |
 | Flip Over tool (only if Fold Sheet is selected). Flips the front and back of the selected Fold Sheet on the Press Sheet. | |
 | Shows/Hides the Inspector window | |
 | Shows/Hides the Mark Sets Inspector window. | |
 | Shows/Hide the Positioning palette | |
 | Submit button. Submits the job with the edited imposition. | |
 | Close button. In the imposition windows, saves your changes and closes the imposition window. Behavior is set in the Preferences. |
doc. version 13.1.1