Browsing your Results
To view your results you can select multiple results in the Results tab, and multiple raster preview windows will open. However, once Raster Preview is launched, it offers an alternative way to browse through your results within a single raster preview window. This way you can avoid switching back and forth between the Results tab and Raster Preview.
To view next and previous results
1 Double-click on a page in the middle of a set of results to launch Raster Preview.
2 Click the Next and Previous buttons to browse forwards and backwards through the results from front to back.
Raster Preview displays the next and previous side results (e.g. Cover Sig 1 Front < > Cover Sig 1 Back < > Cover Sig 2 Front < > Cover Sig 2 Back < > etc.).
3 Hold down the C key while clicking the Next and Previous buttons to browse forwards and backwards through the results from sheet to sheet.
Raster Preview displays the next and previous sheet results (e.g. Cover Sig 1 Back < > Cover Sig 2 Back < > Cover Sig 3 Back, etc.).
To view the first and last results
1 To display the first result, press the Home button.
2 To display the last result, press the End button.
NOTE: If a job consists of 10 signatures: Sig 1 Front is the first result and Sig 10 Back is the last result.
To turn a sheet
If your results have 2 sides (front and back), Raster Preview will always group these results.
1 Select both the front and back of one and the same sheet and double-click.
A single raster preview window will open.
2 Click the Turn Sheet tool (CTRL+T) to toggle the view (front or back).
Alternatively, you can click the Side Switcher in the Light Table palette.
The Turn Sheet tool is disabled if the result only contains one side.
NOTE: The zoom factor, Navigator view and position and Inks separation selection remain the same when you turn a sheet.