Mark Conflicts
Conflicts may arise if a mark overlaps another mark, a mark runs into the page content or bleed zone, or a mark falls outside the area of interest or box. The areas of interest are the Pages, Gutters, Gripper, Press Sheet, etc. for each respective Mark type. For example, press sheet marks must fall inside the Press Sheet.
Clipped
These are the possible actions if a mark falls outside the box or area where it is expected to be drawn.
These are the possible actions if a mark falls outside the box or area where it is expected to be drawn clipped: The mark is clipped to fit in the box and printed.
•Do not Print: The mark is ignored.
•Fail: The job will be aborted. The notify action is selected and an error is displayed for the job.
NOTE: You can choose to be notified by selecting the Notify check box.
Overlaps
These are the possible actions if a mark overlaps with Page Content (Trim), Page Bleed or another mark.
•Print: The mark is printed even if it falls outside the box.
•Do not Print: The mark is ignored.
•Fail: The job will be aborted. The notify action is selected and an error is displayed for the job.
NOTE: You can choose to be notified by selecting the Notify check box.
Include knock-out for conflict checking
When selected, the knock-out area is included for conflict checking.