Slow Down Wheels Overview
The Slow Down Wheels dialog box lists all available rules in the left column.
Click a rule in the left column to display its settings. |
Widths
A press may have wheels at 5 positions on the sheet:
•Drive side of the sheet
•1/3 of the width of the sheet
•Center of the sheet
•2/3 of the width of the sheet
•Operator side of the sheet
Enter the width of the zone you want to create for each wheel or leave the box blank if there is no wheel at this position. The zone is between the bleed boxes of each page.
Keep Symmetrical
Select this check box if the width of the two side wheels (Drive and Operator) must be the same as the width of the 1/3 and 2/3 wheels. If you clear this box, you can edit the 2/3 and Operator widths.
Keep within
Enter values to let the center wheel and the 1/3 and 2/3 wheels deviate from their exact position.
Allow special combinations
Two special combinations of wheels can be selected:
•Center and single side: the center wheel and a single side
•Thirds and single side: the 1/3 and 2/3 wheels and a single side
doc. version 13.1.1