Mark Position
The Position tab in the Details pane contains settings that apply for all of the Mark types. These settings are explained in this section for all Mark types.
Mark
Anchor Point
You can specify the exact position of the mark. This position is defined by a horizontal and a vertical distance from different parts of the sheet or plate.
 |
Target
Reference
Choose a reference for the anchor point from the drop-down list. This reference depends on the Mark type:
•Image Marks
•Image Frame
•Image Trim box
•Bleed
•Sheet Marks
•Sheet
•Image Block
Horizontal
For the horizontal position, select:
•distance...
•to right or left of...
•Left Edge, Right Edge, or Center.
Vertical
For the vertical position, select:
•distance...
•below or above...
•Top Edge, Bottom Edge, or Center.
Print on
•Front side
•Back side
•Both sides. If you select this option, the following check boxes are enabled:
•Mirror position on back
•Mirror content on back
Layer
See “Mark Layers” for information on how layers are used to arrange content:
•Top Marks
•Page Content
•Bottom Marks
doc. version 6.1.1