Re-rendering Results
You can re-render individually selected results (non-imposed flats, pages, or separations). When you do so, only the results of the selected pages or flats are remade - not the entire job.
You may want to re-render results if you have changed your resources (new fonts, color books, etc.). This is also useful if you want to remake aborted results, or remake output when the raster data (Digital Film) is no longer available.
NOTE: You can also re-render the output when the raster data is still available.
To re-render job results, the job must still have the original input documents (i.e. Action on the input channel).
What is the difference between Re-rendering and Re-imaging results?
When you select Re-render, Asanti will re-render and output the selected job results. When you select Re-image, Asanti will not render the results again: It will simply output the existing raster data to the selected output device. Re-rendering therefore completely regenerates the selected job results, but takes more time and uses more resources.
To re-render results
1 Select the Jobs window.
2 Select the Results tab.
3 In the Job Layout or Separations pane, select a flat, page, or separation that has already been successfully processed.
4 Choose Control > Re-render <item>.
TIP: This is different from editing a job, where existing results are not affected by any changes you make.
All scheduled and active tasks after the selected point in the flow are aborted, and re-rendering is started. Any that were made on the first pass will be remade, and the old archives deleted.
To re-render backgrounds (Asanti DQS)
1 Select the Jobs window.
2 Select the Results tab.
3 In the Job Layout or Separations pane, select a flat that has already been successfully processed using Asanti DQS.
4 Choose Control > Re-render backgrounds.