Installing Measurement Devices
The Apogee Client installer installs by default the X-Rite i1 Pro II. You can add or remove additional measurement devices by running the Client installer again.
To install a Measurement Device:
1 Start the Apogee Client installer, and click Next.
 |
2 Select the check-box to accept the terms in the license agreement.
3 Select Custom (when installing from scratch) or Modify (when reinstalling), and click Next.
 |
4 In the Custom Setup pane, select the measurement device(s).
 |
NOTE: The Epson SpectroProofer (ILS30) is not a part of the installer. This device is installed by default and always available in QMS and Apogee Prepress.
5 Click Next to complete the installation.
doc. version 13.1.3