Cogwheel Commands in the Inspector
The cogwheel in the bottom left corner of the Inspector lists a number of commands that are relevant for the selected imposition node or component.
 |
The following commands are displayed depending on the selected node or components:
•Imposition components in Product and Sheet View
Command | Action |
|---|---|
Reset | Resets selection |
Reset All | Resets all production settings |
Auto Impose | Opens the Auto Impose dialog box |
View | Opens the Press Sheet View |
Reset (Fold Sheets) | Resets the layout of the Fold Sheets according to the Press Sheet Layout Rules |
Reset Position | Resets the orientation and flip state to 0° and not flipped |
•Marks in Sheet View
Command | Action |
|---|---|
Reset | Resets selection |
Reset All | Resets all production settings |
Add to Mark Sets | Adds the selection to a Mark Set |
Open in Mark Engraver | Opens the selected Mark in the Mark Engraver |
Manage Mark Sets | Opens the Mark Engraver (from Mark Sets Inspector) |
doc. version 13.1.1