Mark Position
The Position tab in the Details pane contains settings that apply for all of the Mark types. These settings are explained in this section for all Mark types.
Mark
Anchor Point
You can specify the exact position of the mark. This position is defined by a horizontal and a vertical distance from different parts of the sheet or plate.
 |
Target
Reference
Choose a reference for the anchor point from the drop-down list. This reference depends on the Mark type:
•Page Marks
•Page Trim
•Fold Sheet Marks
•Fold Sheet
•Outer Overfold
•Inner Overfold
•Outer Spine
•Inner Spine
•Lowest Page
•Highest Page
•Top Page
•Bottom Page
•Press Sheet Marks
•Press sheet
•Fold sheet blocks
•Page trim block
•Press Sheet Marks (web-based sheets only)
For these web-based targets, you have further options to place the mark on the press sheet. A switch is provided that lets you specify all the items or just a specific one with an index number.
•Ribbon: the vertical sections of a web-based sheet; only applicable for web production schemes with multiple ribbons
•Slit: the line where the sheet is cut into ribbons; only applicable for web production schemes with multiple ribbons
•Cut-off: where the web is cut horizontally
•Horizontal fold: a fold across the web
•Vertical fold: a fold along the web
•Row: cells across the web
 | puts the mark in a specific row: row 2 |
 puts the | puts the mark in all rows |
•Column: cells along the web
•Cell: a single page cell; here you have two input fields, C for Column and R for row, to specify a cell; enter an asterisk for all the cells in a row or column.
 | puts the mark in a specific cell: column 3 of row 1 |
 puts the | puts the mark in all cells |
•Image Marks
•Image Frame
•Image Trim box
•Bleed
•Sheet Marks
•Sheet
•Image Block
Horizontal
For the horizontal position, select:
•distance...
•to right or left of...
•Left Edge, Right Edge, or Center.
Vertical
For the vertical position, select:
•distance...
•below or above...
•Top Edge, Bottom Edge, or Center.
Print on
•Front side
•Back side
•Both sides. If you select this option, the following check boxes are enabled:
•Mirror position on back
•Mirror content on back
Layer
See “Mark Layers” for information on how layers are used to arrange content:
•Top Marks
•Page Content
•Bottom Marks
doc. version 13.1.1